Reprogamacion del toyota corolla compresor en 40 segundos

Todo lo relacionado con Tu Toyota

Moderadores: PegasoD4D, julapatos, Ayocab, Achilles, jony83, manu_mad, Hator

juan-1
Mensajes: 8333
Registrado: 09 Mar 2006 12:48
Ubicación: Madrid
Contactar:

Reprogamacion del toyota corolla compresor en 40 segundos

Mensajepor juan-1 » 24 Oct 2008 17:17

Bueno estoy buscando en la red algo de informacion.
y me he topado con esto,por lo visto discuten si el motor del corolla Ts compressor da 240ps en lugar de los 220ps que anunci,como el lotus Exige.
bien me he encontrado lo siguiente;
The Corolla Compressor requires the use of 98 Octane petrol. This fuel is Mandatory and if any
engine damage is caused due to engine pinking etc., warranty will NOT cover the subsequent cost of
any repairs
If the vehicle is run on a fuel with an octane value of less than this then the following symptoms may
occur:
• Engine pinking
• Lack of performance
• Incorrect fuel economy
• Internal engine damage if the engine is used on the incorrect octane fuel for extended periods.
Cause Of Phenomenon:
The vehicle ECU has 2 internal software maps.
• Map 1 – The ECU uses Map 1 when the correct 98 octane is used. In this condition the
vehicle functions correctly.
• Map 2 – If incorrect grade octane fuel is used the engine may switch to Map 2 to try and
prevent internal engine damage. The engine may pink badly and produce less power

HINT – Engine Damage may still occur if the vehicle is driven for extended periods in this
condition.

Please carry out the following procedure to ensure the ECU is using the correct mapping for 98
Octane fuel:
• Switch on ignition, do not start engine.
• Then for 40 seconds apply full throttle (Do not start engine).
• Start the engine the engine mapping should now be correct for 98 octane fuel.
• Test drive vehicle and ensure engine performs correctly.


vamos que es un ajuste del carburante.

tambien dicen esto.

I didnt think it was an ECU upgrade that re-mapped the extra HP. I was told this at the end of 2005 when the first compressors came out. It was either:

Turn on the ignition, 1 before starting the engine... either:

- Press down the clutch fully for at least 30 or 50 seconds (5 rings a bell), then press the accelerator fully once

OR this rings more bells

- Press down the clutch 5 times 1 after the other.... and try the same method but press the accelerator fully after the whole sequence.


I would also try doing the same methods with the accelerator only, e.g. 30 sec / 5 times. I can only remember bits of what i am told and our compressor is gone now, but as chris mentioned the re-map and i was told this method i thought i'd add my thoughts now as they differ from Chris.

vamos que alguien lo pruebe y si funciona me debe un birra por los 20cv+
2zzge digievolucionado a 2zzsc
Imagen
Find4u distribuidor España de...
ImagenImagenImagenImagen

juan-1
Mensajes: 8333
Registrado: 09 Mar 2006 12:48
Ubicación: Madrid
Contactar:

Mensajepor juan-1 » 24 Oct 2008 17:21

despues de comprobar lo de los cinturones me lo creo todo...
2zzge digievolucionado a 2zzsc
Imagen
Find4u distribuidor España de...
ImagenImagenImagenImagen

Avatar de Usuario
Jose P.
Mensajes: 896
Registrado: 14 Jul 2006 15:53
Coche: Ex-Toyota Corolla Tsport
Ubicación: Menorca

Mensajepor Jose P. » 24 Oct 2008 19:21

No busques mas sobre este tema tan delicado!!!!
SI TIENES DUDAS............. GAS!!!!!!

Avatar de Usuario
despistao
Mensajes: 348
Registrado: 19 Oct 2007 19:20
Ubicación: Madrid

Mensajepor despistao » 24 Oct 2008 22:38

para cuando quieres esas birras??jaja

Avatar de Usuario
despistao
Mensajes: 348
Registrado: 19 Oct 2007 19:20
Ubicación: Madrid

Mensajepor despistao » 24 Oct 2008 22:44

aun que tampoco entiendo muy bien lo que viene a decir, tienes que dejarlo con el contacto dado 40 segundos y luego pisar el acelerador a fondo, luego ya arrancar??

juan-1
Mensajes: 8333
Registrado: 09 Mar 2006 12:48
Ubicación: Madrid
Contactar:

Mensajepor juan-1 » 24 Oct 2008 23:07

pone embrague pisado a fondo y despues de 5 pitidos acelerador a fondo.
2zzge digievolucionado a 2zzsc
Imagen
Find4u distribuidor España de...
ImagenImagenImagenImagen

Avatar de Usuario
jony83
Mensajes: 3658
Registrado: 10 Mar 2006 23:42
Ubicación: zArAgOzA
Contactar:

Mensajepor jony83 » 25 Oct 2008 00:20

y para el TS no encuentras nada??sin hacer brico tuning
Imagen
corolla TS W41D (made in american)

Avatar de Usuario
toni_ts
Mensajes: 119
Registrado: 05 Nov 2007 14:24
Ubicación: Guadalajara
Contactar:

Mensajepor toni_ts » 25 Oct 2008 12:57

Esto es como jugar a ser dios, transformar la bestia.... seria algo interesante para los que tenemos el TS normal. Buena currada juan....
Corolla TS

Avatar de Usuario
085aaron008
Mensajes: 984
Registrado: 04 Feb 2008 23:30
Ubicación: Los Madriles

Mensajepor 085aaron008 » 25 Oct 2008 13:58

jejejeje :twisted: :twisted: :twisted:
Imagen
TODAY, TOMORROW, TOYOTA RACING DEVELOPMENT

Avatar de Usuario
despistao
Mensajes: 348
Registrado: 19 Oct 2007 19:20
Ubicación: Madrid

Mensajepor despistao » 26 Oct 2008 10:29

lo he estado probando, con el embrague pisado a fondo no me pita nada

juan-1
Mensajes: 8333
Registrado: 09 Mar 2006 12:48
Ubicación: Madrid
Contactar:

Mensajepor juan-1 » 26 Oct 2008 17:10

dependiendo de la centralita pone pisando 5 veces el embrague o 5 veces el acelerador.
2zzge digievolucionado a 2zzsc
Imagen
Find4u distribuidor España de...
ImagenImagenImagenImagen

Avatar de Usuario
JaS
Mensajes: 427
Registrado: 13 Dic 2007 11:37
Coche: Ex - Corolla TSport, Yaris 1.33VVTi

Mensajepor JaS » 26 Oct 2008 20:17

juan-1 escribió:pone embrague pisado a fondo y despues de 5 pitidos acelerador a fondo.


No habla de pitidos por ningun lado :roll: To ring a bell, significa "sonar", pero en el sentido de que al tio le "suena" que era asi, vamos que no lo recuerda del todo. Un saludo

Avatar de Usuario
JaS
Mensajes: 427
Registrado: 13 Dic 2007 11:37
Coche: Ex - Corolla TSport, Yaris 1.33VVTi

Mensajepor JaS » 26 Oct 2008 20:26

No obstante es un tema intersante. A ver si los del Compressor nos dan noticias...

Avatar de Usuario
despistao
Mensajes: 348
Registrado: 19 Oct 2007 19:20
Ubicación: Madrid

Mensajepor despistao » 27 Oct 2008 00:57

a mi no me sale na!jajaja

paco tte
Mensajes: 159
Registrado: 08 Ago 2007 12:07

Mensajepor paco tte » 03 Nov 2008 18:38

buuff ke de tiempo sin postear!!

esto me lo teneis ke explicar por ke lo he probado ,no se si bien, pero el caso ke he pisado el embrague durante 40 segundos, he kitado el contacto y cuando he vuelto a darlo han sonado unos pitiditos rapidos ,no se si eran cinco o ke, luego he arrancado y el coche iba igual ke siempre.

pero esto tengo ke mirarlo bien, haber si me entero con el traductor